Focus temp heat pump manual

Current inside temperature Low battery warnings (see pages ) System status Heat On/Cool On (If flashing, see p. 10) Auxiliary heat (Only for heat pumps with auxiliary heat) More Press to view outdoor climate (if outdoor sensor is installed), or to find a misplaced remote control if installed (see page 9) Temperature setting. If you have a heat pump without auxiliary/backup heat connect O or B, not both. If you do not have a heat pump, do not connect B. Wrap bare end of wire with electrical tape. Place a jumper (piece of wire) between Y and W if you are using a heat pump without auxiliary/backup heat. B O G Y W NOT USED R Rc M 4 4 7 Install Batteries. Application Guide AG 3 Introduction This application guide is written to assist the designer in Geothermal heat pump design. It is a companion guide to McQuay’s Catalog , Water Source Heat Pump Design Manual, which discusses Boiler/Tower heat pump design.

ITS Heat Pumps Domestic Heat P ump Product Manual Page 2 of 14 A MESSAGE FROM ITS This manual will focus on the domestic range of heat pumps. 2 PRODUCT INTRODUCTION Below is a graph showing the measured hot water draw-off temperature values of a standard L electrical geyser. The 3 different sets of measurements were done on the same. This video was made by Ryan Nesbitt from Rhino Pools in South Africa. than a week, turn off the heat pump. 4. Find the proper setting on the heat pump temperature control and use the Set Point Lockout or lock the cover on the heat pump controller to discourage further adjustments. 5. Set the pump time clock to start the pump no earlier than AM during the pool heating season. This is the time when nightly.

the heat pump is 80° F air temperature, 80% relative humidity, and 80° F water temperature. As conditions decrease from 80/80/80, the heat pump performance will decrease slightly. Heat Pumps are best utilized to maintain a set water temperature; they are not intended to provide instant or fast heating. It is not reasonable to expect a heat. Temperature setting (see pages ) Auxiliary heat (Only for heat pumps with auxiliary heat) System status HeatOn/CoolOn(If flashing, see page 15) System setting Heat/Cool/Auto/Off/Em Heat (see page 8) Fan setting Auto/On (see page 7) Quick reference to display screen. Title: Focus temp international pool heater manual, Author: uacro3, Name: Focus temp international pool heater manual, Length: 3 pages, Page: 1, Published: Issuu Search and overview.