How to fill manual transmission fluid

Manual transmission fluid top up. In order to top up the oil, you have to locate and unscrew the filling cap. We recommend that you use a syringe or a special pump in order to gradually insert fresh oil into the gearbox sump. Keep checking the oil level as described above in order to ensure that it does not www.doorway.ruted Reading Time: 4 mins. Replace the lower plug once all the fluid is let out. Insert the pump into the top hole and pour the fluid into it. Put fluid into the transmission until it reaches the top hole and then insert the top plug. Get out from under the car, remove the catch pan and jack stands. Lower the car.  · Drain the old lube first and replace the drain plug. Then fill the trans with new gear lube through the filler untill it comes out. let it drain out of there for a little while before you replace the filler plug. The correct level for the lube is at the bottom of the fill plug.

All this is now is re-filling the transmission and re-assembling the underbody panel. 9. Replace the drain plug. Make this fairly snug. Remove the fill plug you loosened in step 0. Put your long-necked funnel into the fill port. Put in quarts of MT fluid. Check to see if any fluid came out the level port. Wipe up any. It would be handy to use a hand oil pump because it is hard to get a funnel on the hole and with a funnel in the hole you can't see as well when it is full. Most times I put to much in because I pour to fast. Fill it until the oil comes out of the fill hole, and put the plug in and your done. Helms manual show a 3 qt. to fill the trans. Pretty straightforward procedure and actually very simple. My procedure does not show you how to check the fluid level it shows you how to refill it,if it i.

Next, find the fill plug on the upper portion of the transmission housing and unscrew it. Then, find the drain plug, and undo that to drain the gearbox. Make sure to have a catch pan ready. After. Adding fluid to a manual transmission is more difficult than adding fluid to an automatic transmission. For an automatic transmission, you just pop the hood and add the fluid into the dipstick hole. For a manual transmission, you have to get under the car. Adding fluid to a manual transmission can be messy. Learn how. Completely drain the transmission fluid. Connect the transmission fluid pump to a bottle and drain out all of the fluid. Pump a small portion of new fluid into the fill plug to flush out any contaminants. Ensure that you have a little more transmission fluid than the volume listed in your owner's manual. Figure 5. Setting up the transmission.